USB 2.0 Adapter Converter for SATA HDD, conect any SATA Device to your USB 2.0 Port!
CHIPSET:NEC-720133, Jmicron-JM20330B2
USB 2.0 Adapter to any Native SATA 3.5' Drive from 80GB up to 500GB. Compatible with Windows ME/2000/XP/2003. Not for MAC!
Adapter plugs directly to your usb 2.0 port on a windows based computer and provides one SATA port (with short cable) to connect directly into your SATA 3.5' HDD. Uses NEC and Jmicron Chip for COnversion. Real Life Test Results show a 12.9 GB file folder with 237 Files transfered in less than 10 minutes. Tested with WD/Maxtor/Seagate/Hitachi SATA drives.
Package includes Adapter cable only, you will need to provide external power to your drive.
USB2.0 to serial ATA translation. It includes the NEC USB2.0 IDE bridge & Serial ATA PHY, Link, Transport. The Serial ATA physical, link, and transport layers are compliant to Serial ATA 1.0 ,The AUS100 converter supports a SATA 1.5GHz data rate & USB2.0 480MHz data rate . The application layer supports both the ATA register command set and PACKET command set, which could drive SATA Hard Disk.
Dimension : 51 * 30 * 17 (mm)
Weight : 19g
With LED Indicated power
Power supply : USB port
need power : under 1W
Support Win-98se,Win-98me need driver
Support Win-2000,Win-xp free driver
Easy install & free driver
Max speed (Read + Write) : 52M Byte
USB2.0 Specification compliant
USB2.0 NEC newest chipset install
Serial ATA 1.0 Specification compliant
Automatic Serial ATA 1.5 Gbps speed negotiation
Support USB2.0 plug & play
Support Serial ATA hot-plug
Ultra low power consumption
Work for both AC and DC couple between the transmitter and the receiver
Provide specified OOB signal detection and transmission
Support Spread Spectrum Clocking to reduce EMI
Support Partial/Slumber power management
Provide adjustable TX signal amplitude and pre-emphasis level
SATA Disk Slave support
Speed :Win-98 .....Read >17 Mbyte , Write >14 Mbyte
Speed :Win-2000,xp .Read >27 Mbyte , Write >25 Mbyte
@
1
Convert USB2.0 to e-SATA interface
Furnish standard e-SATA port for external SATA device
Support Hot-Plug
USB 2.0 to eSATA Adapter
Converts any eSATA device or SATA device with converter cable to connect to any Notebook, Desktop, or Server with available USB 2.0 ports.
Connect eSATA device to high-speed USB 2.0 port
Connect SATA device to USB 2.0 port (requires optional
SATA to eSATA cable type "I" to "L")
Supports Hot-Swap & Plug-n-Play (Windows Me, 2000, XP, 2003 and Mac OS X and above)
Supports Software RAID feature in Windows and Mac OS X
Compact design with no extra power source required
Works on Notebooks and Desktops
RoHS Compliant
|
| 
| 
| 
| 
| 
| 
| 
